The short answer
Garden rooms usually stand on ground screws, a concrete slab or pad plinths. Whichever you pick, the height limit runs from the ground next to the building, highest ground on a slope, to the top of the roof. The base, floor, insulation, ceiling and roof all sit inside that number, so a 2.5 m limit leaves less headroom than it sounds.
A garden room base looks like a builder’s detail. For planning it is a height decision. Under permitted development the height of the building is measured from the ground, so the base you choose, the floor on top of it and the roof above all share one limit. A base that is 100 mm too deep can cost you the headroom you wanted, or the permitted development rights altogether.
This guide covers the three common garden room foundations, how to add up the height budget, the 0.3 m line for raised platforms, and where Building Regulations touch the base. The other limits (area, position, use) are in Class E outbuildings, limit by limit.
The three common bases
Most garden rooms in the UK stand on one of three bases. Each does the same job: carry the floor frame level and clear of damp. They differ in how much ground work they need and how much height they use.
| Ground screws | Concrete slab | Pad or plinth | |
|---|---|---|---|
| How it works | Steel screws driven into the ground, with the floor frame fixed to the tops | A poured concrete platform the size of the room, with the floor frame on it | Small concrete pads or blocks at set points, with the floor frame resting on them |
| Ground it suits | Most gardens, including uneven or sloping ground; the ground decides the screw length | Firm, level ground; heavy builds and larger rooms | Firm, level ground; light timber frames |
| Removable later | Yes: the screws unscrew | No: it is broken out | Largely: the pads can be lifted |
| Height it uses | Often the shallowest, because the frame can sit close to the ground | The slab thickness above the ground plus the frame on it | The pad height plus the frame above |
Treat the height row as a question to put to your installer, not a standard. Two installers can build the same type to different heights. The free check assumes a 150 mm base unless you enter your own, so enter the real figure from your installer’s drawing.
A slab is a permanent decision and adds its own thickness. If it is raised above the surrounding ground, the building is measured from that ground, not from the top of the slab. Pads put the weight on a few points; on a slope they vary in height from one side to the other, which makes the highest-ground rule matter more. Screws let the frame sit low, and the ground decides their length and number.
The height budget: everything above the ground counts
The limit is not the height of the walls. It is the height of the highest point of the building above the ground next to it. In England, article 2(2) of the GPDO 2015 says height is measured from the level of the surface of the ground immediately adjacent to the building or, where that ground is not level, from the highest part of the surface of the ground adjacent to it. The MHCLG technical guidance adds that ground level does not include an addition laid on top of the ground, such as decking. A slab or plinth that lifts the room above the garden reads the same way, but your council decides how it reads on your site.
Base, floor, ceiling, roof
Add up every layer from the ground to the top of the roof:
- the base, from the ground to the underside of the floor frame
- the floor frame, insulation and finished floor
- the room’s internal height and the ceiling finish
- the roof structure and insulation above the ceiling
- the roof deck, membrane and the upstand, fascia or gutter at the edge
On a flat roof the roof edge is also the eaves, and England caps the eaves at 2.5 m as well (Class E.1(f)).
Worked example under 2.5 m
This is an example build-up to show the arithmetic, not a standard. The figures are chosen to make the total easy to follow.
| Layer | Example height |
|---|---|
| Base: floor frame sitting close above the ground | 100 mm |
| Floor frame, insulation and finished floor | 150 mm |
| Internal height, floor to ceiling | 2,000 mm |
| Ceiling finish | 15 mm |
| Roof structure and insulation | 150 mm |
| Roof deck and membrane | 30 mm |
| Upstand or fascia at the roof edge | 55 mm |
| Total from the ground | 2,500 mm |
The 2,000 mm of internal height is what is left. Raise the base by 150 mm and the room is 150 mm shorter inside, or the room goes over 2.5 m and loses its permitted development rights within 2 m of a boundary. Agree the base and the roof build-up before the design is drawn, not after.
Limit
The base is part of the height
Measure the finished building from the ground next to it to the highest point of the roof, upstand and fascia included. If the number is over the limit by even a little, the garden room is not permitted development.
Sloping gardens
In England and Northern Ireland a room on a slope is measured from the highest part of the adjacent ground, so the high side sets the limit even if the low side has a deep base. Scotland measures from the lowest part of the adjacent ground. Wales has its own wording for each limit. The garden room height limits guide covers the datum for each nation, and the boundary height checker works the limit out from a distance and a roof shape.
On a slope, a screw or pad base often lets the frame follow the ground and keeps the high side low. A level slab set on a slope tends to be buried on the high side and raised on the low side. Raise that with your installer.
Slabs, decks and the 0.3 m platform line
Class E says development is not permitted if it includes a verandah, balcony or raised platform (E.1(h)). The MHCLG technical guidance defines a raised platform as one with a height greater than 0.3 m, and says Class E allows garden decking provided it is not more than 0.3 m high.
That line matters for what sits beside the room: a terrace, a deck or a raised patio. On a sloping garden, a deck level with the garden room floor can pass 0.3 m on the low side quickly. Check how high any slab, deck or terrace next to the room stands above the ground at its highest edge. If it is more than 0.3 m, lower it, step it, or plan for a planning application, and describe the whole project honestly on any application, because your council decides whether a deck is part of the room.
Building Regulations on foundations
Planning permission and Building Regulations are separate. A garden room that is exempt from Building Regulations does not have its foundations signed off by building control, though they still have to hold the room up.
In England and Wales, Schedule 2, Class 6 of the Building Regulations 2010 exempts a detached single storey building with a floor area up to 30 m² that contains no sleeping accommodation if either no point of it is less than 1 m from the boundary of its curtilage, or it is built substantially of non-combustible material. A detached building up to 15 m² with no sleeping accommodation is also exempt. If the room sleeps someone, is over 30 m², or is closer than 1 m to the boundary and combustible, it is not exempt, and the foundations are part of what building control looks at. Scotland and Northern Ireland have their own small building classes, set out in garden room building regulations.
Roots, drains and water
Two practical points sit outside the planning limits, so treat them as questions for your installer, not rules from this guide. A base near a mature tree, a hedge or a drain run can be affected by it and affect it in turn, so ask how the installer surveys the plot before fixing base positions. And a base flush with the ground with no air gap under the floor can trap damp, so ask how the floor is ventilated and where water will go, particularly beside a boundary where a neighbour’s land sits lower.
Moving a base to avoid a root can also move the room towards a boundary, which changes the height limit you are measuring against. Settle the position and the base together.
Test the design before you build
The base is the first decision that fixes the height, and the height is what the permitted development case rests on. The free 3D check lets you enter your base height and see the room left under the limit for your nation. If you send the design to your council, for a certificate or a householder application, the £49 supporting report and block plan shows each height from the correct ground. The height limits guide covers the rest of the height rules, and the garden room cost guide prices the base alongside the room.
Sources
Every number in this guide that does not come from our own 3D check was checked against these 7 documents, numbered in the order the text first cites them and read between 11 November 2026 and 18 November 2026. 7 are legislation and government guidance.
- 1legislation.gov.ukThe Town and Country Planning (General Permitted Development) (England) Order 2015, Schedule 2, Part 1, Class E (legislation.gov.uk, revised text)
- 2legislation.gov.ukGPDO 2015, article 2: height measured from the highest ground next to the building; article 2(3) land; flats are not dwellinghouses for Part 1
- 3GOV.UKPermitted development rights for householders: technical guidance (MHCLG, September 2019), pages 6 to 13 and 41 to 46
- 4legislation.gov.ukThe Building Regulations 2010, Schedule 2, Class 6 (small detached buildings), England and Wales
- 5legislation.gov.ukGPDO (Scotland) 1992, article 2: interpretation, height measured from the lowest ground
- 6legislation.gov.ukGPDO 1995, article 1: interpretation, article 1(5) land, height measurement
- 7legislation.gov.ukTown and Country Planning Act 1990, section 192: certificate of lawfulness of proposed use or development



