The short answer
In England a garden room with any part, the roof edge included, within 2 m of a boundary can be no more than 2.5 m high (Class E, E.1(e)(ii)). Further away the limit is 4 m for a dual-pitched roof and 3 m for any other. Wales, Scotland and Northern Ireland change the zone and the heights.
How the checker works
The checker reads the same table of heights and distances as the free 3D check, so the two never disagree. For each nation it knows the size of the boundary zone, the height allowed inside it, the height allowed outside it for each roof shape, and the eaves limit.
England counts the whole building: if any part is inside the 2 m zone, every part is held to 2.5 m. Wales and Scotland limit only the parts inside the zone, so a dual-pitched room can rise towards its ridge once it is clear. Northern Ireland limits the eaves inside its 2 m zone and allows 4 m overall.
Limit
The limit counts the roof edge
Measure to the roof edge, not the wall
The distance that matters is from the nearest point of the building to the boundary. Class E and the technical guidance for England (page 43) both say “any part of the building”, and the roof overhang is part of the building. So a wall 2 m from the fence with a 120 mm overhang reads as inside the zone, and the free check measures it that way. Enter the roof edge figure.
Gutters and overhangs count
If you are close to 2 m, draw the overhang. On the height limits guide the same point is worked through for each roof shape, and the block plan guide shows how the distances go on the drawing.
Which ground to measure from
England and Northern Ireland measure height from the highest part of the ground next to the building (GPDO 2015, article 2(2), and its Northern Ireland twin). Scotland measures from the lowest. Wales measures each part from the ground immediately next to that part. On a sloping garden, tick the box and the checker shows the rule for your nation.
What it does not check
This is one rule. It does not test how much of the garden is covered, whether the room sits forward of the house, the use, or land where the rules change, such as a conservation area. The half-the-garden calculator covers the 50% rule, and the building regulations checker the 1 m rule. The 3D check runs them all together on your own plot.
Sources
Every number in this guide that does not come from our own 3D check was checked against these 9 documents, numbered in the order the text first cites them and read between 11 November 2026 and 18 November 2026. 9 are legislation and government guidance.
- 1legislation.gov.ukThe Town and Country Planning (General Permitted Development) (England) Order 2015, Schedule 2, Part 1, Class E (legislation.gov.uk, revised text)
- 2legislation.gov.ukGPDO 2015, article 2: height measured from the highest ground next to the building; article 2(3) land; flats are not dwellinghouses for Part 1
- 3GOV.UKPermitted development rights for householders: technical guidance (MHCLG, September 2019), pages 6 to 13 and 41 to 46
- 4legislation.gov.ukThe Town and Country Planning (General Permitted Development) Order 1995, Schedule 2, Part 1, Class E as substituted for Wales by SI 2013/1776 (W.177), revised text
- 5legislation.gov.ukGPDO 1995, article 1: interpretation, article 1(5) land, height measurement
- 6legislation.gov.ukThe Town and Country Planning (General Permitted Development) (Scotland) Order 1992, Schedule 1, Part 1, Class 3A as substituted by SSI 2011/357 and amended by SSI 2020/437, revised text
- 7legislation.gov.ukGPDO (Scotland) 1992, article 2: interpretation, height measured from the lowest ground
- 8legislation.gov.ukThe Planning (General Permitted Development) Order (Northern Ireland) 2015, Schedule, Part 1, Class D, revised text
- 9legislation.gov.ukGPDO (Northern Ireland) 2015, article 2: interpretation, height from the highest ground, original as at 1 October 1973


